zrallod wrote::wave: Is that oil seeping thru? The biggest problem I see is that you did not cook the block to get the oil saturation out of the pores in that Alum. Block. Maybe your Iron cement will hold or maybe not. Good luck, I hope it works. Bobodu, I repaired a K-301 5 years ago with JB weld and it still going strong.
Yes, you are correct, that was oil seeping thru. I thought last night it was just damp. Iron cement didn't work. I cleaned it all out and am back to square one. Should I heat the area to get all the oil out? I used a oil & grease remover solvent and an air hose but obviously that wasn't enough. JB weld will be the next try.